Disassembly Procedure - Mitsubishi Electric Mr.SLIM PKH-1.6FKA Technical & Service Manual

11

DISASSEMBLY PROCEDURE

PKH-3FKA-E
OPERATING PROCEDURE
1. Removing the lower side of the indoor unit from the instal-
lation plate
(1) Remove the 2 screws.
Hang the indoor unit hangers to the catches on the instal-
lation plate.
Screws
2. Removing the right side panel
(1) Remove the 2 screws of the right side panel:one on the
bottom and the other on the upper right-hand side.
(2) Disconnect the connector from the adapter case.
(3) Sliding the right side panel to the right, pull it out toward
you.
3. Removing the indoor controller board
(1) Remove the right side panel.
(2) Remove the screw of the electrical parts box cover, and
remove the cover.
(3) Disconnect the connectors on the indoor controller board.
(4) To unhook the catches on the right-hand side of the indoor
controller board, pull the left-hand side toward you and lift
up the cover to the right. Then the indoor controller board
can be removed.
4. Removing the electrical parts box
(1) Remove the right side panel.
(2) Remove the screw of the electrical parts box cover, and
remove the cover.
(3) Remove the room temperature thermistor and the indoor
coil thermistor.
(4) Disconnect the vane motor connector on the indoor con-
troller board.
(5) Remove the 2 screws of the electrical parts box.
(6) Disconnect the connector of the heater lead wire connec-
tor.
(7) Disconnect the connector of the fan motor lead wire.
(8) Remove the electrical parts box.
Figure 1
Metal fixture
Figure 2
Photo 1
Photo 2
70
PHOTOS&ILLUSTRATION
Hanger of indoor unit
Catch of installation plate
Terminal cover
Connector
Electrical parts box cover
Indoor controller
board
Room temperature thermistor
Indoor coil thermistor
Connector
Indoor controller
board
Right side panel
Electrical parts
box cover
Catches
Screws
Electrical parts
box