Personal Safety Warnings - LAMINOX KING HEAT 6 User Manual

designed. Any other use is considered unsuitable and therefore hazardous. The
manufacturer shall not be considered liable under any circumstances for damage
caused by unsuitable, erroneous or irrational use.
Remove all the packaging and check the contents are complete. In case of doubt, do
not use the heat pump. Contact your supplier. Keep the packaging elements out of
reach of children, as they can be dangerous.
Improper installation or placement of equipment or accessories may cause
electrocution, short circuit, leakage, fire, or other damage to the equipment. Use only
accessories or optional equipment designed specifically to work with the products
presented in this manual. Do not modify, replace or disconnect any safety or control
device without first consulting the manufacturer.
When it is decided not to use any more the heat pump, disable the parts that could
represent a potential hazard.

2.2 Personal safety warnings

Always wear appropriate personal protective equipment (gloves, safety goggles, etc.)
when performing installation and/or maintenance on the unit.
Do not touch any switch with wet fingers. Touching a switch with wet
fingers may cause electric shock. Before accessing the electrical
components of the heat pump, disconnect the main power supply
completely.
Disconnect all electricity sources before dismantling the cover panel from
the electric panel or before making any connections or accessing
electrical parts.
To avoid electrocutions, be sure to turn off the power for 1 minute (or more) before
servicing the electrical parts. Even after 1 minute, always measure the voltage at the
terminals of the main circuit capacitors and other electrical parts before touching them
and make sure that the voltage is equal to or less than 50 V dc.
When the cover panels are disassembled, the energized parts can be easily
accessed. Never leave the unit unattended during installation or during maintenance
work when the cover panel is removed.
Do not touch the refrigerant pipes, water piping, or internal parts during and
immediately after operation. Pipes and internal parts may be excessively hot or cold,
depending on the use of the unit.
The hands may be burned by cold or heat in case of improperly touching pipes or
internal parts. To avoid injury, wait until the pipes and internal parts return to their
normal temperature. Alternatively, if access is required, be sure to wear appropriate
safety gloves.
- 4-