Table of Contents
Advertisement
Email： support@iauvon.com
8. Use the "T" button you
can set the massage
time from 10-60 minutes.
The time remaining is
automatically counted
down. Then the unit will
automatically turn off af-
ter time is finished.
NOTE: It is recommend-
ed that each area should
not use this device for
more than 30 minutes at
a time. Stop using it if the
pain is relieved.
9. Long press the "T" button for 10 seconds, if all
the icons on the screen stop flashing, then you
can adjust the backlight brightness (low, medium,
and highlight) with the "+" button and adjust the
backlight duration (10s/30s/60s) with the "-" but-
ton (the backlight duration will be displayed on
the top left of the screen). The screen will return
to the original interface after 3 seconds of no op-
eration.
14
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the USER MANUAL and is the answer not in the manual?
Questions and answers
Please help
how to remove & store pads
To remove and store Auvon electrode pads:
1. Turn off the device by pressing the power button for a few seconds.
2. Grab a corner of the electrode pad and slowly peel it away from the skin. Do not pull the wire, and avoid touching the gel.
3. Place the sticky side of the pad on the transparent film or pad holder.
4. Gently remove the lead wire connector from the electrode pads.
5. Store the electrode pads in the storage bag and reseal tightly to prevent drying out.
6. Keep them at room or cool temperature (5°C-35°C/41°F-95°F) and away from direct sunlight.
7. Organize the wires with a cable tie and store everything in the pouch.
This answer is automatically generated
Need manual for tens unit model number TA3224
Description on what each modes is/does?
The Auvon device has multiple modes that serve different purposes. Some modes are designed for TENS (Transcutaneous Electrical Nerve Stimulation), which helps relieve pain, while others are EMS (Electrical Muscle Stimulation) modes, used to stimulate and build muscles. The device allows switching between these modes using a "mode" button. When changing modes, the device defaults to a lower intensity level for safety. Each mode has a number on the display, and the blinking channel (A or B) indicates which output is being adjusted.
This answer is automatically generated