Table of Contents
Advertisement
5
Getting connected to
the Web Interface
Web Interface -
Frame
30
Using the Web Interface
Connection between the sensor and your device is established via Bluetooth.
The following instructions are based on using Windows 10.
☞
1.
Power on the iCA202.
☞
If you intend to use the Web Interface with iCA202 make
sure the external Bluetooth antenna is attached.
2.
On your computer go to Start Menu > Settings > Devices.
☞
Activate Bluetooth if not yet switched on.
3.
Click "Add Bluetooth or other devices".
☞
Make sure that computer and sensor are in reach for a
Bluetooth connection.
4.
Click Bluetooth and select the sensor from the list.
Wait for the connection to be established.
☞
The sensor can be identified by its serial number.
5.
Go to Start Menu > Settings > Network & Internet.
Under Advanced Network Settings click "Change Adapter
Options".
In the Network Connections page double-click on "Bluetooth Net-
work Connection".
Finally, right-click on the sensor that you have just added and select
Connect using > Access Point from the context menu.
6.
Open a browser on your computer and enter the URL:
http://www.icasetup.leica-geosystems.com
User name is "leica", as password enter the serial number of the
sensor.
7.
Start configuring the iCA202 using the Web Interface.
For mobile devices it is only required to pair the sensor via Bluetooth.
☞
The header section contains a status information bar.
The footer includes information on the connected receiver, its serial number
and firmware version.
The frame will always be visible independent of which tab you open
☞
for further configuration.
Status information bar
The status bar shows the satellite status, internet connection, antenna config-
uration and receiver status information.
.
Using the Web Interface
Advertisement
Table of Contents
