Adjusting Pwrgenerator Setpoints - Generac Power Systems PWRgenerator 9 kW Owner's Manual

Operation
•
PWRcell Battery SoC is below AutoStopSoC set-
point of the PWRgenerator.
Proceed as follows to manually start or stop the PWR-
generator from the PWRcell Inverter ICM:
1. Press left and right arrow keys to access PWRgen-
erator device page. Press center button to enter
PWRgenerator menu.
2. Press up and down arrows to highlight Start Gen or
Stop Gen depending on desired action. Press cen-
ter button to select.
3. Press left and right arrow keys to highlight either
Confirm or Cancel from pop-up confirmation win-
dow. Press center button to select.

Adjusting PWRgenerator Setpoints

PWRgenerator setpoints are adjusting using the inverter
control panel. See PWRcell Inverter owner's manual for
further information.
Proceed as follows to adjust PWRgenerator setpoints:
1. Press left and right arrow keys to access PWRgen-
erator device page. Press center button to enter
PWRgenerator menu.
2. Press up and down arrow keys to highlight Mod.
Settings. Press center button to enter menu.
3. Press up and down arrow keys to highlight desired
setpoint. Press center button to select.
4. Press up and down arrow keys to adjust setpoint
value. Press center button to deselect the setpoint.
5. See Figure 3-13. Press down arrow key to scroll to
the bottom of the list and select Save. Press center
button.
Figure 3-13. PWRgenerator Setpoint Screen Example
22
013752
Owner's Manual for PWRgenerator Air-Cooled Generators