Table of Contents
Advertisement
D. Install Decorative Barrier Front/Hood
WARNING! Risk of Fire! Install ONLY decorative barrier
fronts approved by Hearth & Home Technologies. Unap-
proved decorative barrier fronts could cause fireplace to
overheat.
This fireplace has been supplied with an integral
barrier to prevent direct contact with the fixed glass
panel. DO NOT operate the fireplace with the barrier
removed.
Contact your dealer or Hearth & Home Technologies if
the barrier is not present or help is needed to properly
install one.
1. Remove decorative barrier front by lifting up and away
from appliance.
2. Install four shoulder bolts as shown in Figure 10.9.
3. Hang decorative barrier front onto shoulder bolts.
4. Install hood on appliance by inserting into the two hood
clips. See Figure 10.9.
Figure 10.9 Install Decorative Barrier front and Hood
58
Heat & Glo • SL-5F-IFT, SL-7F-IFT Installation Manual • 2638-980 Rev. H • 6/22
Note: Refer to Section 3 for individual decorative barrier
front dimensions as installed on appliance.
Advertisement
Table of Contents
