Supermicro H13DSH User Manual page 63

Chapter 4: BIOS
Console Redirection Settings
Out-of-Band Mgmt Port
The feature selects a serial port in a client server to be used by the Microsoft Windows
Emergency Management Services (EMS) to communicate with a remote host server. The
options include COM1 and SOL.
Terminal Type
Use this feature to select the target terminal emulation type for Console Redirection.
Select VT100 to use the ASCII character set. Select VT100+ to add color and function
key support. Select ANSI to use the extended ASCII character set. Select VT-UTF8 to use
UTF8 encoding to map Unicode characters into one or more bytes. The options include
VT100, VT100+, VT-UTF8 and ANSI.
Bits per second
Use this feature to set the transmission speed for a serial port used in Console Redirection.
Make sure that the same speed is used in the host computer and the client computer. A
lower transmission speed may be required for long and busy lines. The options include
9600, 19200, 57600, and 115200.
Flow Control
Use this feature to set the flow control for Console Redirection to prevent data loss caused
by buffer overflow. Send a "Stop" signal to stop sending data when the receiving buffer
is full. Send a "Start" signal to start sending data when the receiving buffer is empty. The
options include None, Hardware RTS/CTS, and Software Xon/Xoff.
Data Bits EMS
Use this feature to set the data transmission size for Console Redirection. The default
value is 8.
Parity EMS
A parity bit can be sent along with regular data bits to detect data transmission errors.
Select Even if the parity bit is set to 0, and the number of 1's in data bits is even. Select
Odd if the parity bit is set to 0, and the number of 1's in data bits is odd. Select None if
you do not want to send a parity bit with your data bits in transmission. Select Mark to add
a mark as a parity bit to be sent along with the data bits. Select Space to add a Space as
a parity bit to be sent with your data bits. The default value is None.
Stop Bits EMS
A stop bit indicates the end of a serial data packet. Select 1 Stop Bit for standard serial
data communication. Select 2 Stop Bits if slower devices are used. The default value is 1.
63