Table of Contents
Advertisement
8/36
Digital axis control VT-HMC...1X | Safety instructions
Bosch Rexroth AG, Edition 01.2021, RE 30239-B
2 Safety instructions
2.1
ABOUT THIS CHAPTER
The product has been manufactured according to the generally accepted codes of
practice. However, there is still a risk of personal injury and damage to property if
you do not observe this chapter and the safety instructions in this documentation.
▶ Read this documentation completely and thoroughly before working with the
product.
▶ Keep this documentation in a location where it is accessible to all users at all
times.
▶ Always include the required documentation when you pass the product on to
third parties.
2.2
INTENDED USE
The product is an electrical component.
You may use the product as follows:
• For controlling one or two hydraulic axes in position control, force control,
alternating control (position/pressure or force) and velocity control in the
operating modes of direct valve control, drive-controlled position control,
drive-controlled positioning and positioning block mode, optional position
synchronization master/slave, average, min/max (optional) and optional force
synchronization.
The product is intended exclusively for professional use and not for private usage.
Operation according to the intended use also implies that you have read
and understood this documentation completely, especially chapter 2 "Safety
instructions".
2.3
IMPROPER USE
Any use other than described in the section "Intended use" is considered as
improper and is therefore not permitted.
The installation or use of inappropriate products in safety-relevant applications
could result in unintended operating states in the application which in turn
could cause personal injuries and/or damage to property. Therefore, please only
use a product for safety-relevant applications if this use is expressly specified
and permitted in the documentation of the product. For example, in explosion-
protection areas or in safety-related parts of a control (functional safety).
Bosch Rexroth AG does not assume any liability for damage caused by improper
use. The user assumes all risks involved with improper use.
Improper use includes, but is not limited to:
• operating the digital axis control outside the specified performance limits and
operating conditions, especially the prescribed ambient conditions;
• the use as safety-related part of controls in the sense of DIN EN ISO 13849.
Functional safety must be realized by means of appropriate, additional
components.
Advertisement
Table of Contents
