Removing The I/O End Cap - Cisco 3200 Series Upgrade Manual

Chapter 2 Replacing Cards in the Cisco 3230 ISR Rugged Enclosure

Removing the I/O End Cap

To remove the I/O end cap, follow these steps:
Using a 3/8-inch socket wrench to loosen the four 1/4-20 bolts on the end cap.
Step 1
Note
Step 2 Carefully remove the I/O end cap and pull the end cap I/O cable out from under the card stack to free
the end cap (see
Figure 2-4
Place the end cap on your work surface.
Step 3
OL-15983-01
If a protective end cap cover (see
ports on the I/O end cap, loosening the four 1/4-20 mounting bolts on the protective end cap
allows you to remove the protective end cap and the I/O end cap from the extrusion.
Figure 2-4).
I/O End Cap Removal
Figure 2-16) is used to provide weatherproof protection for the
Cisco 3200 Series Router Hardware Upgrade Guide
Card Replacement Process
2-5