Honeywell SV2 Series User Manual page 5

amps/110 Watts, Hold 0.5 amps/40 Watts
200-240 VAC, 50/60 Hz, Vtest/Vrms 240VAC, Pull in (2 sec) 0.6
amps/110 Watts, Hold 0.3 amps/40 Watts
All voltages are -15%/+10%VAC
Hold in voltage is 94VAC at 63°C (145°F) or -6%
1
All values at 20°C (68°F)
External Load Relay Ratings:
ILK / Interlock: 24, 100-240 VAC, 50/60 Hz, 8 amps
VPS / Valve Proving contact: 24, 100-240 VAC, 50/60 Hz, 0.1 amps
POC / Proof of Closure contact: 24, 100-240 VAC, 50/60 Hz, 0.1 amps
SSOV Class Ratings:
All valves Class A rated (EN161)
Safety combination valve for control of gaseous fluids in gas consuming
appliances in accordance with international standards
Pressure Ratings
Fuel/air versions (V2V): 1.45 psi / 0.1 kg/cm
NOTE: In most cases the fuel/air valve inlet pressure needs to be limited/
regulated between limits depending on the application.
On/off versions (V2F): 10 psi / 0.7 kg/cm
MOPD: 9.94 psi / 685 mbar
Valve Opening Time:
1 second maximum at 68 °F (20 °C)
Valve Closing Time:
1 second maximum at 68 °F (20 °C)
CV Ratings:
1.0 in (DN25) valve with flanges 0.5 in/0.75/1/1.25 = DN15/20/25/32:
6.8/9.3/10.1/10.6
1.5 in (DN40) valve with flanges 1 in/1.25/1.5/2 = DN25/32/40/50:
21.5/25.6/25.9/26.8
2.0 in (DN50) valve with flanges 1 in/1.25/1.5/2 = DN25/32/40/50:
27.2/36.7/40.7/45.0
Mounting Position:
Vertical to 90 degrees from vertical, refer to
Material:
Valve body: Die-cast aluminum alloy
Electrical enclosure: Valox™ 553
Closing Spring:
AISI 302 steel
Valve Plunger:
11SMn30 steel with electroless nickel plating sliding on anti-friction
bearing
Seals and Gaskets:
FVMQ (Fluorsilicone)
Torsion and Bending Stress:
Pipe connections meet group 2 according to EN161 requirements
Electrical Equipment:
AC rectified coils with separated rectifier and power saving circuitry inside
the cover
Coil Insulation Solenoid Valves:
Insulation material is specified according to class F
Duty Cycle:
Coils are suitable for permanent energizing via SV2 Series valve
electronics with power saving
Weight:
1 in. valves (DN25)
On/Off: 18.8 lb (8.5 kg)
Fuel/Air: 20.0 lb (9.1 kg)
1.5 and 2 in (DN40/50) valves
On/Off: 46.1 lb (20.9 kg)
Fuel/Air: 50.2 lb (22.8 kg)
Dimensions:
-
See Figs. 2 6.
Approvals:
cULus (Underwriters Laboratories): Electrically operated valves. Vol 11
valve body, Vol 12 control boards. (24VAC, 100-120 VAC valves)
File MH1639
UL429, UL353 and UL1998.
SV2 Series Safety Shut-off Valves
V2F, V2V
1
/ 100 mbar
2
2 / 689 mbar
Fig. 19.
SV2 SERIES SAFETY SHUT-OFF VALVES USER MANUAL
NEMA 1 / IP20 valves: Recognized
NEMA 4 / IP66 valves: Listed
FM7400 Approved (100-120VAC, 24VAC PENDING). On/Off valves only.
CSD-1 Acceptable (24VAC, 100-120 VAC valves)
CSA Approved for US and Canada (100-120 VAC valves, 24VAC PENDING)
Certificate #70086210
ANSI Z21.20-2014 CAN/CSA-C22.2 NO. 60730-2-5-14 /
UL 60730-2-5
ANSI Z21.21-2015 CSA 6.5-2015
Commercial / Industrial Certified (24VAC, 100-120 VAC valves)
FCC Part 15, Class A Digital Device
Complies with standard ANSI Z21.21-CSA6.5 (24VAC, 100-120 VAC)
CE Approved per (100-120VAC, 200-240VAC valves):
EN 1643:2014 Safety and control devices for gas burners and gas
burning appliances - Valve proving systems for automatic shut-off
valves
EN 13611:2015 Safety and control devices for gas burners and gas
burning appliances - General requirements
EN 1854:2010 Pressure sensing devices for gas burners and gas burning
appliances
EN 161:2011 + A3:2013 Automatic shut-off valves for gas burners and
gas appliances
EN 12067-2:2004 Gas/air ratio controls for gas burners and gas burning
appliances. Electronic types.
EN 126:2012 Multifunctional controls for gas burning appliances
EN 298:2012 Automatic burner control systems for burners and
appliances burning gaseous or liquid fuels
Pin number 0063CQ1175
Certificate # 18GR0759/00
NOTE: The Pressure Module is not a stand-alone product
and must be used with a SV2 Series valve and thus
is specified as part of the valve approvals.
Applicable Gas Types:
Natural gas or liquid propane (LP) only
EU designations: 2nd and 3rd families
Environmental Ratings:
Electrical enclosure: NEMA 1 / IP20 or NEMA 4 / IP66
Storage/Shipping Conditions:
-40 to 150 °F (-40 to 66 °C)
95% RH at 104 °F (40 °C) and 30 in. Hg (1013.25 mbar)
Maximum storage duration of 6 months at these conditions
Operating/Fluid Temperature Range:
Premix (V2V) models: +5 to 145 °F / -15 to 63 °C
On/Off (V2F) models: -40 to 145 °F / -40 to 63 °C
Operating Humidity Range:
95% RH at 104 °F (40°C) for 14 days
Non-condensing for NEMA 1 / IP20 valve versions
5
MCR37133