Honeywell SV2 Series User Manual page 219

Address Type
Dec Hex
243 F3
244 F4
245 F5
246 F6
247 F7
248 F8
General
249 F9
250 FA
251 FB
252 FC
253 FD
254 FE
255 FF
24 18
25 19
63 3F
HGP / LGP
64 40
65 41
SV2 Series Safety Shut-off Valves
V2F, V2V
Valve Intelligence Description
Model Levels
Valve factory data
Valve factory data
Valve factory data
Valve factory data
Valve factory data
Valve factory data
All Standard
Valve factory data
Valve factory data
Valve factory data
Valve factory data
Valve factory data
Valve factory data
Valve factory data
Minimum applicable pressure range for Pressure
Module used.
Shown in user selected pressure units.
Maximum applicable pressure range for Pressure
Module used.
Shown in user selected pressure units.
Hi-/Lo-Gas Pressure function status
All Standard
Operating pressure value stored for Low gas
pressure (LGP) limit setpoint during setup as
measured during maximum burner firing rate.
Shown in user selected pressure units.
Operating pressure value stored for High gas
pressure (HGP) limit setpoint during setup as
measured during minimum burner firing rate.
Shown in user selected pressure units.
SV2 SERIES SAFETY SHUT-OFF VALVES USER MANUAL
Data Content
Type
62 x Char
Main electronics factory data string of characters ended by
62 x Char
either ASCII-0 or end of register array.
Two characters per register
62 x Char
62 x Char
62 x Char
62 x Char
62 x Char
Main electronics factory data string of characters ended by
62 x Char
either ASCII-0 or end of register array.
62 x Char
Two characters per register
62 x Char
62 x Char
62 x Char
62 x Char
Pressure.
U16
See Holding Register 74 for selected units.
Pressure.
U16
See Holding Register 74 for selected units.
0 =HGP and LGP function disabled
1 =HGP and/or LGP function enabled; no
pressure setup has been performed
2 =HGP and/or LGP function enabled; pressure
is within requested limits
0x10 =In commissioning mode
Enum
0x20 =In HGP/LGP test mode
0x81 =Invalid HGP and/or LGP parameters
0x82 =Detected pressure lower than Lo-Gas
limit setting
0x83 =Detected pressure higher than Hi-Gas
limit setting
Pressure.
U16 See Holding Register 74 for selected units.
0=Invalid value
Pressure.
U16 See Holding Register 74 for selected units.
0=Invalid value
219