Table of Contents
Advertisement
DNP3
The DNP3 communication protocol is available on the RS-485 serial interface and the Ethernet SCADA
and optical Ethernet ports. The figure below shows the default DNP3 configuration. You can change it
based on your system administrator's indications.
NOTICE
The DNP3 outstation ID is 1.
—
Figure 16 Default DNP3 parameters
You have more detailed information on the DNP3 communication protocol used in appendix "DNP3" on
page B59.
Downloading the DNP3 device profile
You can also download the DNP3 profile from your device for consultation or troubleshooting purposes.
To do so:
1 From the page shown on Figure 16, click Download DNP3 Device Profile. Your browser asks whether
you want to save or open the generated file.
2 Click Save and, in the Browse window that appears, select a location for the file that you are about
to save.
The CoreSense M10 creates a .xml file in the directory that you chose.
Configuring communication protocols
17
Advertisement
Table of Contents
