Updating With A Usb Key - ABB CoreSense M10 User Manual

Updating with a USB key

NOTICE
If the update process do not seem to work on your first try, try it again with a different
brand of USB key or update remotely (see "Updating with a web browser (preferred
method)" on page 48).
1 From your computer, extract the zip file sent to you by the service representative at the root level of a
USB key.
2 Open the CoreSense M10 cabinet.
3 Shutdown the instrument using the main power switch.
—
Figure 53 Instrument main power switch
4 Insert the USB key on the USB port of the CoreSense M10 cabinet.
—
Figure 54 Instrument USB port
5 Turn on the instrument using the main power switch (see Figure 4). The update process will start
automatically and take a few minutes.
Messages will appear on the local screen during the update process. Also, the instrument may
reboot two or three times depending on the required updates for your system. The update process
is complete once a message appears indicating to remove the USB key and reboot.
6 When this message appears, remove the USB key.
7 Power off the system for a few seconds and power it on again.
You may be asked to calibrate the screen by touching the 4 crosses displayed on the screen.
50
User Guide