Diagnosing System Sources; Changing The Active Source - ABB CoreSense M10 User Manual

Diagnosing system sources

When diagnosing CoreSense M10 problems, system sources could be at fault. From the Maintenance
page, there are certain actions that you can perform to achieve a diagnostic.
—
Figure 68 The Source diagnostics page

Changing the active source

There are two sources in a CoreSense M10 system. To switch between active sources:
1 Click Source diagnostics from the Maintenance page. The Source diagnostics page appears (see
Figure 68 above).
2 Click Change active source.
After a few seconds, the name of the active source will be indicated at the top of the page.
Advanced maintenance D97