Advertisement
Quick Links
Owner's Guide and Installation Manual
Attach sales receipt to this card and retain as your proof of purchase
DATE OF PURCHASE:
MODEL NUMBER:
To register your fixture, please visit our website www.montecarlofans.com
3LD48XXXD Series Fan
CUL Model NO. : 3LD48XXD
RETAILER NAME:
RETAILER ADDRESS:
6.4 kg
14.1 lbs
Total fan weight with light
Advertisement
Related Manuals for Monte Carlo Fan Company Linden 3LD48 D Series
Summary of Contents for Monte Carlo Fan Company Linden 3LD48 D Series
- Page 1 Owner’s Guide and Installation Manual 3LD48XXXD Series Fan CUL Model NO. : 3LD48XXD Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: RETAILER ADDRESS: MODEL NUMBER: To register your fixture, please visit our website www.montecarlofans.com 6.4 kg 14.1 lbs Total fan weight with light...
-
Page 2: Cautions And Warnings
Cautions and Warnings WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING READ AND SAVE THESE INSTRUCTIONS Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70) including fire-rated construction. - Page 3 Before you begin installing the fan, Switch Before installing this fan make sure the Use metal outlet box suitable for fan power off at Service panel and lock outlet box is properly installed to the support and use only the screws provided service disconnecting means to prevent house structure.
- Page 4 SAFETY CABLE INSTALLATION Wall switch White (Neutral) Power source Black (Live) Ground/Green Lag screw Black Blue Slot Safety cable White Washer Lock washer Install ball end of downrod into mounting For Canadian installation and for USA fan Make wiring connections using wire connectors provided as indicated above.
- Page 5 Light fixture Switch housing cap Shipping stabilizers Remove shipping stabilizers from motor Remove switch housing cap by removing Remove the tap from bottom of the switch housing cap. assembly. the set screws. Keep screws. Place switch housing cap over light lead Install the blade assembly to motor using wires and Installation light fixture onto the the preinstalled screws.
- Page 6 Glass Final cap Rubber washer Hex nut Finial Reverse switch Raise glass in order to guide pull chains Align hole in center of final cap with thread Setting the reverse switch in the down through appropriate holes in glass, aligning rod, allowing pull chains to come through position will result in downward airflow threaded rod on light fixture with hole in...
-
Page 7: Troubleshooting
Troubleshooting or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning and lock the service panel to prevent the power from being switched back on accidentally. If the service panel cannot be locked to prevent the power from being switched on accidentally, securely fasten a warning sign to the service panel. - Page 8 Apr.2022...