Advertisement
19
Glass
Rubber washer
Hex nut
Raise glass in order to guide pull chains
through appropriate holes in glass, aligning
threaded rod on light fixture with hole in
middle of the glass and push up gently
allowing threaded rod to come through
hole. (Note: Be sure pull chain for fan
operation does not rub against bulb during
operation).
Install the rubber washer and hex nut to
hold the glass. DO NOT OVER TIGHTEN IT.
Install fan and light kit pull chains to
preassembled pull chains on fan. Pull
chains provided.
© 2022 Monte Carlo Fan Collections
20
Final cap
Finial
Align hole in center of final cap with thread
rod, allowing pull chains to come through
appropriate holes in the final cap, and push
up. Thread center pull chain through hole in
finial and secure glass to light fixture by
tightening the finial. DO NOT OVER TIGHTEN
the finial as glass may crack or break.
6
21
Reverse switch
Setting the reverse switch in the down
position will result in downward airflow
and setting the switch in the up position
will result in upward airflow.
Note: Reverse switch must be set either
completely down or completely up for fan
to function. If the reverse switch is set in
the middle position, fan will not operate.
3/2022
Advertisement
