V-ZUG WineCooler V4000 90 Operating Instructions Manual page 23

Malfunction
Illumination is not
working.
Illumination is flash-
ing.
Illumination is flash-
ing and an acoustic
signal is emitted.
Possible cause
▪ Sabbath mode is active.
▪ Message A1: Door sensor
is faulty.
▪ If no A1 message ap-
pears: LED illumination is
defective.
▪ Appliance door is left
open for longer than 3
minutes.
▪ Appliance door was not
closed properly.
▪ Appliance door is left
open for longer than 5
minutes.
▪ Appliance door was not
closed properly.
▪ Door sensor is faulty.
▪ The «TouchOpen» door
opening mechanism is
defective.
10 Trouble-shooting
Solution/Measures
▸ Open the appliance door manu-
ally (e.g. with a standard suction
cup).
▸ Hold the button depressed
for 3 seconds.
▪ If the illumination turns on: The
problem is remedied.
▪ If the appliance switches off
(«OF» in the display):
▸ Switch the appliance back on
again and contact Customer Ser-
vices.
▸ Contact Customer Services.
▸ Close the appliance door.
▸ Close the appliance door.
– If the alarm is still being emit-
ted:
▸ Touch any button to acknow-
ledge the alarm.
▸ Check the door seal, contents
and installation situation for any
obstructions.
– After acknowledging 3×, an er-
ror message appears: A1.
▸ Contact Customer Services.
▸ If the door opener does not re-
tract, disconnect the appliance
from the mains, wait about 10
seconds and then reconnect it to
the mains.
▸ If the door opener still does not
retract, remove by pulling it out.
▸ Close the appliance door.
▪ The appliance door can be
opened manually (e.g. with a
standard suction cup).
▸ Contact Customer Services.
23