Controls And Display - Hover-1 HELIX Operation Manual

CONTROLS AND DISPLAY

PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
TURNING YOUR DEVICE ON/OFF
Power On: Place your Helix flat on the floor and press the power
button (located on the rear of your Helix) once. Check the LED
indicator (located in the center of your Helix). The battery indicator
should be lit, indicating the Helix is powered on.
Power Off: Press the power button once.
MAT SENSORS
There are four sensors under the foot mats of your Helix.
When riding the hoverboard, you must ensure you are stepping on
the foot mats. Do not step or stand on any other area of your
hoverboard.
The hoverboard may vibrate or spin in one direction if weight and
pressure are applied to only one foot mat.
BATTERY INDICATOR
The display board is located in the middle of the Helix.
• A green LED Light indicates the hoverboard is fully charged.
• A red flashing LED light and beeping indicates low battery.
• A yellow flashing LED light indicates the hoverboard is charging.
When the LED light turns red, please recharge the Helix.
RUNNING INDICATOR
When the operater triggers the foot mats, the running indicator LED
will light up, which means that the hoverbaord has entered the
running state.
When the hoverboard encounters an error during operation, the
running LED light will turn red (for more details, see "SAFETY ALERTS" on
page 18).
6