Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Hover-1 DRIVE
Summary of Contents for Hover-1 DRIVE
- Page 1 E L E C T R I C H O V E R B O A R D O PE RATI ON M A NUAL H1 DR I VE...
- Page 2 HELMETS SAVE LIVES! Always wear a properly itted helmet that complies with CPSC or CE safety standards when you ride your E Scooter. Correct Fit: Make sure your helmet covers your forehead. Incorrect Fit: Forehead is exposed and vulnerable to serious injury.
- Page 3 • To avoid collisions, falls, and loss of control, please learn how to ride the Drive safely. • You can learn how to ride the Drive by reading the operation manual and watching videos. • Hover-1 can not be held liable for damage or injury caused by failure to understand and/or failure to follow the warnings and instructions in this manual.
-
Page 4: Safety Instructions
• Keep the Drive away from heat sources, direct sunlight, humidity, water, and any other liquids. • Do not operate the Drive if it has been exposed to water, moisture, or any other liquids to prevent electric shock, explosion, and/or injury to yourself and damage to the Drive. - Page 5 • Do not operate or allow others to operate the Drive until the user understands all instructions, warnings, and safety features described in this manual. • Check with your doctor if you have a medical condition that could a ect your ability to use the Drive.
-
Page 6: Package Contents
INTRODUCTION The Drive hoverboard is a personal transporter. Our production processes are developed with strict testing for each hoverboard. Operating the hoverboard without following the contents of this manual may lead to damage to your hoverboard or bodily injury. PACKAGE CONTENTS •... -
Page 7: Operating Principals
The Drive uses digital electronic gyroscopes and acceleration sensors to control balance and motion, depending on the user's center of gravity. The Drive also uses a control system to operate the motors that are located within the wheels. The Drive has a built-in inertia dynamic stabilization system that can assist with balance when moving forward and backward, but not while turning. -
Page 8: Controls And Display
PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY TURNING YOUR DEVICE ON/OFF Power On: Place your Drive lat on the loor and press the power button (located on the rear of your Drive) once. Check the LED indicator (located in the center of your Drive). The battery indicator should be lit, indicating the Drive is powered on. -
Page 9: Before Riding
Practice using the Drive at slower speeds in a lat, open area before taking the Drive out into public areas. PRE RIDE CHECKLIST Ensure that your Drive is in proper working order each time you ride. If a part of the hoverboard does not function correctly, please contact our Customer Support Center. -
Page 10: Safety Precautions
You should check with local o icials to ensure you are complying with these laws. Hover-1 is not liable for tickets or violations given to riders who do not follow local laws and regulations. • For your safety, always wear a helmet that meets CPSC or CE safety standards. - Page 11 • Do not operate the Drive when you are restless or sleepy. • Do not ride your Drive o of curbs, ramps, or in a manner similar to a skateboard. Do not attempt to operate in a skate park or empty pool.
- Page 12 • Do not ride your Drive near motor vehicles or on public roads. • Do not travel up or down steep hills. • The Drive is intended for use by a single individual, DO NOT attempt to operate the Drive with two or more people.
- Page 13 • Do not ride the Drive o -road, near or over potholes, cracks, or uneven pavement or surfaces. • Keep in mind that you are 4.5 inches (11.43 cm) taller when operating the Drive. Make sure to go through doorways safely.
- Page 14 (as shown in the diagram below). Keep your weight on the foot that is still on the ground, otherwise the Drive may begin to move or vibrate, making it di icult to step on evenly with your other foot. When you...
- Page 15 Having any anxiety or reservation about stepping on may cause you to panic and trigger unwanted movement. When you irst begin using your Drive, the fastest way to move in your desired direction is to focus in that direction. You will notice that just thinking about which way you would like to go will shift your center of gravity, and that subtle movement will propel you in that direction.
- Page 16 Try staying relaxed and focus on inding your center of gravity to maintain full control of your Drive. Dismounting your hoverboard can be one of the easiest steps, yet when done incorrectly, may cause you to fall. To properly dismount from a stopped position, lift your dominant leg up and set your foot down on the ground behind you (STEP BACK).
-
Page 17: Operating Range
If your Drive is unbalanced, vibrating, or not turning properly, you can follow the steps below to calibrate it: • First, place the Drive on lat ground or the loor. The foot mats should be even with each other and not tilted forward or backward. Make sure the charger is not plugged in and the hoverboard is turned o . -
Page 18: Safety Alerts
15 seconds. • If a high discharge current is produced during use (such as driving up a steep slope for a long period of time), the Drive will power o and stop after 15 seconds. - Page 19 • If you charge the hoverboard while it is powered on, you will see a yellow lashing light on the hoverboard that indicates it is charging. •After fully charging your Drive, unplug the charger from your Drive and the power outlet.
-
Page 20: Battery Care / Maintenance
• Do not connect or attach the Drive or the battery to a power supply plug or directly to a car’s cigarette lighter. • Do not place the Drive near a ire or leave it out in direct sunlight. Heating the Drive can break or ignite the battery inside the device. - Page 21 • Do not use your Drive if the battery begins to emit odor, overheats, or begins to leak. • Do not touch any leaking materials or breathe fumes emitted. • Do not allow children or animals to touch the battery.
-
Page 22: Care And Maintenance
• Do not let the Drive come into contact with sharp objects, as this will cause scratches and damage. • Do not allow the Drive to fall from high places, as doing so may damage the internal circuitry. • Do not attempt to disassemble the Drive. -
Page 23: Fcc Statement
FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Please note that changes or modi ications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. -
Page 24: Warranty
WARRANTY For warranty information, please visit us at: www.hover-1.com Manufacturer: DGL Group, Ltd. 2045 Lincoln Highway, Edison, NJ 08817 TEL: 732 692 5000 A ix Serial Number Label Here:... - Page 25 @Hover1Rideables @RideHover1 @RideHover1 www.Hover-1.com...