Controls And Display - Hover-1 RANGER PRO Operation Manual

CONTROLS AND DISPLAY

PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY
TURNING YOUR DEVICE ON/OFF
Power On: Take your device out of the box and place it flat on the
floor. Press the power button (located on the rear of your device)
once. Check the LED indicator (located in the center of your
device). The battery indicator light should be lit, indicating the device
is powered on.
Power Off: Press the power button once.
This model also has self-balance function. Generally, the device will
activate the self-balance function when the device is powered on. If
the device doesn't activate the self-balance function, please press
the power button twice when the scooter is on.
MAT SENSOR
There are four sensors under the foot mats on your hoverboard. When
the user steps off the scooter mats, it will automatically initiate
self-calibration.
When riding the scooter, you must ensure you are stepping on the
foot mats. Do not step or stand on any other area of your scooter.
The hoverboard may vibrate or spin in one direction, if weight and
pressure are applied to only one foot mat.
BATTERY INDICATOR
The display board is located in the middle of the hoverboard.
• Green LED light indicates the hoverboard is fully charged.
• Red flashing LED light and beeping indicates low battery.
• Blue light indicates the board is charging.
When the LED light turns red, please recharge the device.
RUNNING INDICATOR
When the operator triggers the foot mats, the Running Indicator LED
will light up, which means that the system enters the running state.
When the system has an error during operation, the running LED light
will turn red (for more details see SAFETY ALERTS).
6