Hover-1 ALL-STAR 2.0 Operation Manual
  1. Manuals
  2. Brands
  3. Hover-1 Manuals
  4. hoverboards
  5. ALL-STAR 2.0
  6. Operation manual

Hover-1 ALL-STAR 2.0 Operation Manual

Hide thumbs Also See for ALL-STAR 2.0:
Table of Contents

Advertisement

Quick Links

OP E RAT I ON M A N U A L
DS A- S T R 2

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ALL-STAR 2.0 and is the answer not in the manual?

Questions and answers

Related Manuals for Hover-1 ALL-STAR 2.0

Summary of Contents for Hover-1 ALL-STAR 2.0

  • Page 1 OP E RAT I ON M A N U A L DS A- S T R 2...
  • Page 2 HELMETS SAVE LIVES! Always wear a properly tted helmet that complies with CPSC or CE safety standards when you ride your scooter. Correct Fitting: Make sure your helmet covers your forehead. Incorrect Fitting: Forehead is exposed and vulnerable to serious injury.
  • Page 3 PLEASE READ THE USER MANUAL THOROUGHLY. Failure to follow the basic instructions and safety precautions listed in the user manual can lead to damage to your ALL-STAR 2.0, other property damage, serious bodily injury, and even death. Thank you for purchasing the Hover-1 ALL-STAR 2.0 Electric Scooter.
  • Page 4 ALL-STAR 2.0. • Do not use the ALL-STAR 2.0 if it has been dropped or damaged in any way. • Repairs to electrical equipment should only be performed by the manufacturer.
  • Page 5 • Do not operate or allow others to operate the ALL-STAR 2.0 until the user understands all instructions, warnings and safety features described in this manual. • Check with your doctor if you have a medical condition that could affect your ability to use the ALL-STAR 2.0.
  • Page 6 ALL-STAR 2.0 or bodily injury. This manual is designed to give you the information you need for the safe operation and maintenance of your ALL-STAR 2.0. Please read it thoroughly before riding your ALL-STAR 2.0. PACKAGE CONTENTS •...

  • Page 7: Specifications

    The ALL-STAR 2.0 uses digital All-STAR 2.0nic gyroscopes and acceleration sensors to control balance and motion, depending on the user's center of gravity. The ALL-STAR 2.0 also uses a control system to drive the motors that are located within the wheels. The ALL-STAR 2.0 has a built-in inertia dynamic stabilization system that...

  • Page 8: Controls And Display

    PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY TURNING YOUR DEVICE ON/OFF Power On: Take your ALL-STAR 2.0 out of the box and place it flat on the floor. Press the power button (located on the rear of your ALL-STAR 2.0) once. Check the LED indicator (located in the center of your ALL-STAR 2.0).

  • Page 9: Bluetooth Speaker

    The All-STAR 2.0 has a powerful built-in wireless speakers so you can play your music while riding. PAIRING THE SPEAKER 1) Turn on your All-STAR 2.0 and the speakers will “Ping” to announce that it’s waiting for a Bluetooth connection. This will indicate your ®...

  • Page 10: Before Riding

    ALL-STAR 2.0. Before you ride, learn the functions of the various mechanisms on your scooter. Practice using these elements of your ALL-STAR 2.0 at slower speeds in a flat, open area before taking the ALL-STAR 2.0 out in public areas. PRE-RIDE CHECKLIST Ensure that your ALL-STAR 2.0 is in proper working order each and...

  • Page 11: Safety Precautions

    Hover-1 is not liable for tickets or violations given to riders who do not follow local laws and regulations. • For your safety, always wear a helmet that meets CPSC or CE safety standards.
  • Page 12 Running Indicator light is green. Do not step on if the Running Indicator light is red. • Do not try to open or modify your ALL-STAR 2.0. Doing so, voids the manufacturer warranty and may cause your ALL-STAR 2.0 to fail, resulting in injury or death.
  • Page 13 • Do not travel up or down steep hills. • The ALL-STAR 2.0 is intended for use by a single individual, DO NOT attempt to operate the ALL-STAR 2.0 with two or more people. • Do not carry anything while riding the ALL-STAR 2.0.
  • Page 14 • Do not attempt any stunts or tricks with your ALL-STAR 2.0. • Do not ride the ALL-STAR 2.0 in dark or poorly lit areas. • Do not ride the ALL-STAR 2.0 off road, near or over potholes, cracks or uneven pavement or surfaces.
  • Page 15 ALL-STAR 2.0 may begin to move or vibrate, making it difficult to step on evenly with your other foot. When you are ready, shift your weight to the foot already placed on the ALL-STAR 2.0 and step on with your second foot quickly and evenly (as described in the diagram below).
  • Page 16 Find your center of gravity. If your weight is distributed correctly on the foot mats and your center of gravity is level, you should be able to stand on your ALL-STAR 2.0 just as if you were standing on the ground.
  • Page 17 ALL-STAR 2.0. Dismounting your ALL-STAR 2.0 can be one of the easiest steps, yet when done incorrectly, may cause you to fall. To properly dismount, from a stopped position, lift one leg up and set your foot back down on the ground (STEPPING BACK).

  • Page 18: Balance & Calibration

    OPERATING RANGE The ALL-STAR 2.0 can travel a distance up to 7 miles on a fully charged battery in ideal conditions. The following are some of the major factors that will affect the operating range of your ALL-STAR 2.0.

  • Page 19: Safety Alerts

    ALL-STAR 2.0 will power off and stop suddenly, possibly causing the rider to lose balance or fall off. • If any or both tires are blocked, the ALL-STAR 2.0 will alert you with the flashing lights after 10 seconds.
  • Page 20 ALL-STAR 2.0 within 15 seconds. • While sustaining a high discharge current during use (such as driving up a steep slope for a long period of time), the ALL-STAR 2.0 will alert you, stop using the ALL-STAR 2.0 within 15 seconds.

  • Page 21: Battery Care / Maintenance

    • Do not connect or attach the ALL-STAR 2.0 or the battery to a power supply plug or directly to a car’s cigarette lighter. • Do not place the ALL-STAR 2.0 or batteries near a fire, or into direct sunlight. Heating the ALL-STAR 2.0 and/or the battery can cause additional heating, breaking, or ignition of the battery inside the ALL-STAR 2.0.
  • Page 22 Use of any other charger or cable voids the manufacturer warranty. • Do not use your ALL-STAR 2.0 if the battery begins to emit odor, overheats, or begins to leak. • Do not touch any leaking materials or breathe fumes emitted.

  • Page 23: Fcc Statement

    FCC STATEMENT NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
  • Page 24 @RideHover1 @RideHover1 @RideHover1 www.Hover-1.com...

  • Page 25: Care And Maintenance

    All-STAR 2.0nic components, destroy the battery, and/or distort certain plastic parts. • Do not dispose of the ALL-STAR 2.0 in fire as it may explode or combust. • Do not expose the ALL-STAR 2.0 to contact with sharp objects as this will cause scratches and damage.

  • Page 26: Warranty

    WARRANTY For warranty information, Please visit us at: www.hover-1.com Affix Serial Number Label Here:...

This manual is also suitable for:

Dsa-str2

Table of Contents