Agilent Technologies 8860 User Manual page 10

1 Safety Information
General safety precautions
To ensure safe equipment operation, adhere to the following safety practices:
•
•
•
•
•
Replace faulty or frayed power cords immediately. Contact your Agilent service
WA RNING
representative.
•
•
•
•
•
•
•
•
•
•
10 Agilent Gas Sample Selector for 8860 and 8890 Safety and Installation Manual
Dot not use flammable gas (such as H
Perform periodic leak checks on all supply lines and pneumatic plumbing.
Do not allow gas lines to become kinked or punctured. Place lines away from
foot traffic and extreme heat or cold.
To avoid exposure to potentially dangerous voltages, disconnect the instrument
from all power sources before removing protective panels.
Your product must only use the power cord that was shipped with this product.
Do not use this power cord with any other product.
The instrument should be placed in a suitable location with sufficient ventilation
to remove gases. Make sure there is enough space around the instrument for it
to cool off sufficiently.
Do not turn on the Power Supply if there is a possibility of any electrical
damage. Instead, disconnect the power cord, and contact your Agilent office.
The supplied power cord must be inserted into a power outlet with a protective
earth ground connection.
Do not change the external or internal grounding connections as this could
endanger you or damage the Power Supply.
The Power Supply is properly grounded when shipped. You do not need to
make any changes to the electrical connections or to the Power Supply chassis
to ensure safe operation.
Do not place containers with flammable liquids on this Power Supply. Spillage
of the liquid over hot parts may cause fire.
Never try to repair or replace any component that is not described in this
manual without the assistance of an Agilent service engineer. Unauthorized
repairs or modifications will result in rejection of warranty claims.
Always disconnect the AC power cord before attempting any type of
maintenance.
The customer should not attempt to replace the fuses in the Power Supply.
Damage can result if the Power Supply is stored under unfavorable conditions
for prolonged periods (for example, subject to heat, water, and so forth).
). Use inert gas (such as N
2
) instead.
2