Shipping Instructions; Cleaning Instructions; Disposal Instructions - Agilent Technologies 8860 User Manual

Gas sample selector

Hide thumbs Also See for 8860:

Table of Contents

Safety Information

Shipping Instructions

Follow these steps to prepare your Gas Sample Selector for shipping:

1 Cap every inlet and outlet port.

2 Cap all inlet and outlet tubing.

3 Always include the power cord kit and USB cable with the Gas Sample Selector.

To keep the Gas Sample Selector surface clean, refer to the following:

•

Disposal of the Gas Sample Selector must be carried out in accordance with all

(environmental) regulations applicable in your country.

Agilent Gas Sample Selector for 8860 and 8890 Safety and Installation Manual

Switch the GC off.

Remove the GC power cable from the mains.

Disconnect the Gas Sample Selector power cable.

Use a soft (not hard or abrasive) brush to carefully brush away all dust and dirt.

If the outer case is dirty, clean it with a soft, clean cloth dampened with mild

detergent. Never clean the inside.

Never use alcohol or thinners to clean the Gas Sample Selector. These

chemicals can damage the case.

Do not get water on the electronics components.

Do not use compressed air to clean.

Table of Contents

8890