Table of Contents
Advertisement
Chapter 7
Problem
Printed barcodes cannot be read.
I want to reset the printer.
I want to delete the data transferred from
the computer.
I want to cancel the current print job.
I want to reset the incrementing field.
The media cannot be fed to the beginning
of a label.
Data is being sent to the printer, but the
POWER indicator is not flashing green.
52
Solution
Print labels so that barcodes are aligned with the print head
as shown below.
1
2
1 Print head
2 Barcode
3 Printing orientation
We recommend printing the barcodes with [Give priority to
quality] selected from the [Quality] options.
Try using another scanner.
To reset the printer and delete all transferred data, follow these
steps:
1 Press and hold the
2 Press and hold the
button until the POWER indicator turns orange and the
STATUS indicator flashes green.
3 While holding down the
(Feed) button 6 times.
4 Release the
(Power) button.
All of the transferred data from the computer will be deleted,
and the printer will be reset to its factory settings.
Make sure that this printer is turned on, and then press the
(Power) button.
Hold down the
(Print) button, until the POWER and STATUS
indicators flashes orange 3 times.
Use the Custom Label Tool to apply the correct paper
settings to the printer.
Check that the sensors are correctly positioned.
For more information, see Checking the Sensor Position
on page 9.
Make sure that the USB cable is securely connected to the
printer, or try using another USB cable.
For WLAN (TD-2125NWB/2135NWB only) or Bluetooth
(TD-2125NWB/2135NWB only) connection, check that the
appropriate LED is lit.
3
(Power) button to turn the printer off.
(Feed) button and the
(Power) button, press the
(Power)
Advertisement
Table of Contents
