Cutting Roll Paper - Brother TD-2020A User Manual

Chapter 2
Figure 1
NOTE
The sensor is at this position when the
printer is purchased.
Figure 2
10
Figure 3
2
1 Back of media
2
2 Black mark
3 4 mm or more
4 Centre line
5 Reflective/black mark sensor
NOTE
When using receipt paper with the
maximum width of 63 mm, make a black
mark at least 9 mm long from either the left
or right edge of the paper so that the
reflective/black mark sensor can detect
the black mark. If the black mark is too
short, it cannot be detected by the
reflective/black mark sensor.

Cutting Roll Paper

Roll paper can be cut using the printer's tear
bar. Pull one edge of the ejected paper up
and diagonally towards the other edge.
CAUTION
The tear bar is sharp. To avoid injury, do not
touch the tear bar.
2
1
2
3
4
5
2