Installing A Media Roll And Loading Fanfold Paper - Brother TD-2020A User Manual

Installing a Media Roll
and Loading Fanfold
Paper
We recommend genuine Brother Media
Roll. Genuine Brother fanfold media is
not available at this time.
a
Press and hold the
turn the printer off.
Press the cover release lever (1) on
either side and lift up to open the Media
Roll compartment top cover.
b
Open the media guides by lifting up the
media guide adjustment lever (1) and
pulling the media guides outwards.
NOTE
The media guides are shipped fully open
from the factory.
2
(Power) button to
1
1
c
Follow the steps below to install a Media
Roll or load fanfold paper in your printer.
 Installing a Media Roll
1
Install the Media Roll so that the
labels feed with the side to be
printed on facing up (1), as
shown.
1
 Use Media Rolls with an outer roll
dimension of 127 mm or less. Use
Media Rolls designed for TD series
printers. We recommend using
Brother Media Rolls as some Media
Rolls may not be suitable.
 Install the Media Roll facing the
correct direction. If the Media Roll is
not installed correctly, the printer will
not print on the correct side of the
paper or label.
 When using media with the labels
rolled up on the inside, insert the roll
in the opposite direction to that
shown in sub-step 1 of step c, so
that the print side of the labels is on
the outside of the roll.
Printing
2
7