Using Infrastructure Mode And Wireless Direct Simultaneously; Using Wps Wi-Fi Protected Setup(Tm) - Brother TD-2020A User Manual

Chapter 2
e
You can change the connection mode
by pressing the
keeping the (Power) button held
down. The flashing indicators change
each time you press the
as it toggles between connection
modes.
f
Release the (Power) button when
both the POWER and Wi-Fi indicators
turn green.
g
Use your computer or mobile device to
select the SSID of the printer ("DIRECT-
*****_TD-2135NWB").
If required, enter the Password
("213*****", where***** is the last five
digits of the printer's serial number).
NOTE
• The serial number label is located on the
base of the printer. You can also confirm
the serial number by printing the printer
information.
• Use the "Printer Setting Tool" to change
the printer's network settings.
• The "Printer Setting Tool" also allows you
to apply the network settings to multiple
printers.
• You cannot connect to the Internet via
Wi-Fi while using Wireless Direct. To use
the Internet, connect using a Wi-Fi router
or access point (Infrastructure Mode).
• We recommend setting a new Wireless
Direct password using the "Printer Setting
Tool" to protect your printer from
unauthorised access.
Using Infrastructure Mode
and Wireless Direct
Simultaneously
Wireless Direct allows you to connect the
printer to your computer or mobile device
directly, without a Wi-Fi router or access
point.
16
(Print) button whilst
(Print) button
2
a
Set the printer to Infrastructure Mode
and Wireless Direct.
• Using a Windows computer
a. Launch the "Printer Setting Tool"
on your computer.
b. Click the Communication
Settings button.
c. Click General > Communication
Settings.
d. Confirm that the Infrastructure
and Wireless Direct option is
selected as the Selected
Interface setting.
Using WPS Wi-Fi Protected
Setup(TM)
a
Confirm that your Wi-Fi router or access
point has the WPS symbol.
b
Place the printer within range of your
Wi-Fi router or access point. The range
may differ depending on your
environment. For more information, see
the instructions provided with your Wi-Fi
router or access point.
c
Press and hold
seconds until STATUS indicator
flashes green.
d
Press the WPS button on your Wi-Fi
router/access point. When the
connection is established, the STATUS
indicator is lit in green.
For more information, see the instructions
provided with your Wi-Fi router or access
point. When the connection is established,
both the POWER and Wi-Fi indicators turn
green.
Computers and mobile devices that are on
the same network as the printer will have
access to the printer.
2
(Feed) button for ten