Attaching The Embroidery Unit - Brother SE2000 Operation Manual

Embroidering Preparation
e While pressing in the lever on embroidery foot "Q"
with your finger, place the embroidery foot bar above
the needle clamp screw.
1 Embroidery foot bar
2 Needle clamp screw
3 Presser bar
Secure embroidery foot "Q" with the presser foot
f
holder screw, making sure that embroidery foot "Q" is
vertical.
a
1 Mounting notch
2 Presser foot holder screw
g Hold the embroidery foot in place with your right
hand, and then use the included screwdriver to
securely tighten the presser foot holder screw.
CAUTION
• Use the included screwdriver to firmly tighten
the screw of the embroidery foot. If the screw
is loose, the needle may strike the presser foot.
The needle may break, possibly resulting in
injury.
h Touch to unlock all keys and buttons.
78
a
c
b

Attaching the embroidery unit

IMPORTANT
• Before attaching the embroidery unit, be sure
to turn off the machine. Otherwise, the
machine may be damaged.
• Keep your hands and other objects away from
the embroidery carriage and frame when they
are moving. Otherwise damage or malfunction
may occur.
CAUTION
• Do not move the machine with the embroidery
unit in place. The embroidery unit may be
dropped and cause injury.
Turn off the machine.
a
b Pull the flat bed attachment off to the left.
Slide the tab on the cover of the connection port in the
c
direction of the arrow to open the cover.
Note
• Be sure to close the cover of the connection port
when the embroidery unit is not being used.