Table of Contents
Advertisement
e
Hold the quilting foot in place with your right hand,
and tighten the presser foot holder screw using the
screwdriver with your left hand.
1 Presser foot holder screw
CAUTION
• Be sure to securely tighten the screws with the
included screwdriver. Otherwise, the needle
may hit the quilting foot. The needle may
break, possibly resulting in injury.
f
Use both hands keeping the fabric taut, and then
move the fabric at a consistent pace in order to sew
uniform stitches roughly 2.0 mm - 2.5 mm (approx.
1/16 inch - 3/32 inch) in length.
a
g
After sewing is finished, slide the feed dog position
switch lever to
(to the right as seen from the rear
of the machine) and turn the handwheel to raise the
feed dogs.
1 Stitch
■ Satin stitching using the sewing speed
controller
A decorative stitch can be sewn by changing the stitch
width of a satin stitch. If the machine is set so that the
stitch width can be adjusted using the sewing speed
controller, the stitch width can quickly and easily be
adjusted. When this function is set, the foot controller
must be used to sew.
Connect the foot controller.
a
b
Attach zigzag foot "J".
c
Touch
and set [Width Control] (page 1 of the
settings screen) to [ON].
The machine is now set so that the stitch width can
be controlled with the sewing speed controller.
The screen appears as shown below.
d
Select stitch.
No.
1-33
Stitch
• For details, refer to "Stitch Chart" on page 45.
Memo
• Although the stitching results differ depending on
the type of fabric being sewn and the thickness of
the thread being used, for best results, adjust the
stitch length to between 0.3 and 0.5 mm (1/64 and
1/32 inch).
e
While sewing, slide the sewing speed controller to
adjust the stitch width.
• Adjust the sewing speed with the foot controller.
a
b
f
When you are finished sewing, set [Width Control]
back to [OFF].
Utility Stitches
1 Narrower
2 Wider
65
3
Advertisement
Table of Contents
