Chapter 1 Getting Ready; Names Of Machine Parts - Brother SE2000 Operation Manual

1
Chapter
Note
• Be sure to install the latest software.
Refer to "Updating Your Machine's Software" on
page 116.

Names of Machine Parts

■ Main parts
e
d
c
b
a
o
n
m
p
y
x
w
u
v
1 Top cover
2 Thread guide plate (page 22)
3 Thread guide cover
4 Bobbin winding thread guide and pretension disk
(page 22)
5 Spool cap (page 21)
6 Spool pin (page 21)
7 Bobbin winder (page 21)
8 LCD (liquid crystal display) (page 14)
GETTING READY
f
g
h
i
j
k
l
r
t
9 Operation panel (page 11)
0 Knee lifter mounting slot (page 44)
A Knee lifter (page 44)
B Operation buttons and sewing speed controller
(page 10)
C Flat bed attachment (page 11, page 40)
D Thread cutter (page 26)
E Needle threader lever (page 27)
F Handwheel
Turn the handwheel toward you (counterclockwise) to raise and
lower the needle to sew one stitch.
G Handle
Carry the machine by its handle when transporting.
H Presser foot lever
Raise and lower the presser foot lever to raise and lower the
presser foot.
I Feed dog position switch
Use when lowering the feed dogs for free motion quilting* or
button fitting, and when raising the feed dogs. (page 58)
When the feed dogs are lowered, return to their original raised
position after sewing is finished. The feed dogs are raised when
the machine starts sewing.
* The presser foot for free motion quilting is sold separately
with some models.
J Main power switch (page 12)
K Power supply jack (page 12)
L Foot controller (page 34)
M Air vent
The air vent allows the air surrounding the motor to circulate.
Do not cover the air vent while the machine is being used.
N Foot controller jack (page 34)
O USB port (for a USB flash drive) (page 73, page 100)
IMPORTANT
• Do not insert anything other than a USB flash
drive into the USB port. Anything else may
damage the machine.
Names of Machine Parts
9
1