Replacing The Needle; Checking The Needle - Brother SE2000 Operation Manual

Sewing and embroidery machine
Table of Contents

Advertisement

Replacing the Needle

CAUTION
• Only use recommended home sewing machine
needles. Use of any other needle may break
the needle, possibly resulting in injury.
• Never use bent needles. Bent needles can
easily break, possibly resulting in injuries.

Checking the needle

Before using the needle, place the flat side of the needle on a
flat surface and check that the distance between the needle
and the flat surface is even.
1
2
d
c
e
Note
• The machine needles are consumables. Replace
the needle in cases such as those described
below.
- If an unusual sound is produced when the needle
enters the fabric. (The tip of the needle may be
broken or dull.)
- If stitches are skipped. (The needle may be bent.)
- Generally, after completing one project, such as
a piece of clothing.
Replacing the needle
Use the screwdriver and a new needle that has been
determined to be straight according to the instructions in
"Checking the needle" on page 29.
a
Press
(Needle position button) once or twice to
raise the needle.
b
Place fabric or paper under the presser foot to cover
the hole in the needle plate to prevent the needle from
falling into the machine.
1 Flat side
2 Needle type marking
3 Flat surface
4 Even
5 Not even
c
Touch
.
 The screen changes, and all keys and operation
buttons are locked (except
CAUTION
• When replacing the needle, be sure that you
have touched
lock all keys and buttons, otherwise injuries
may occur if the "Start/Stop" button or any
other button is pressed and the machine starts.
c
d
d
Follow steps
to
page 30 for removing the presser foot.
e
Hold the needle with your left hand, and then use a
screwdriver to turn the needle clamp screw toward
you (counterclockwise) to remove the needle.
• Do not apply a strong force when loosening or
tightening the needle clamp screw, otherwise certain
parts of the machine may be damaged.
• The needle clamp screw can also be turned with the
disc-shaped screwdriver.
f
With the flat side of the needle toward the rear of the
machine, insert the new needle until it touches the
needle stopper. Using the screwdriver tighten the
needle clamp screw by turning it clockwise.
1
CAUTION
• Be sure to insert the needle until it touches the
needle stopper and securely tighten the needle
clamp screw with the screwdriver, otherwise
the needle may break and cause injury.
e
g
g
Follow steps
to
page 30 for reattaching the presser foot.
h
Touch
to unlock all keys and buttons.
Replacing the Needle
).
on the operation panel to
"Replacing the presser foot" on
1 Needle stopper
"Replacing the presser foot" on
29
1

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ns2850d

Table of Contents