Brother SE2000 Operation Manual page 12

Names of Machine Parts
■ Needle and presser foot section
i
h
g
f
e
1 Needle bar thread guide (page 26)
2 Needle plate (page 41)
3 Needle plate cover (page 24)
4 Bobbin cover/bobbin case (page 24, page 104)
5 Feed dogs
The feed dogs feed the fabric in the sewing direction.
6 Presser foot
The presser foot applies pressure consistently on the fabric as
the sewing takes place. Attach the appropriate presser foot for
the selected stitch.
7 Presser foot holder (page 31)
8 Presser foot holder screw (page 31)
9 Buttonhole lever (page 56)
■ Embroidery unit
1 Frame-securing lever (page 82)
2 Embroidery unit connection (page 78)
3 Carriage (page 78)
4 Release button (page 79)
10
■ Operation buttons
b
a
c
1 "Start/Stop" button
Press the "Start/Stop" button to start or stop sewing.
The button changes color according to the machine's
operation mode.
Green:
Red:
Orange:
2 Reverse stitch button
Press the reverse button to sew reverse or reinforcement
stitches depending on the selected stitch pattern. (page 36)
3 Reinforcement stitch button
Press the reinforcement button to sew a single stitch
repeatedly and tie-off. (page 36)
For character/decorative stitches, press this button to end with
a full stitch instead of at a mid-point.
The LED beside the button automatically lights up while the
stitch is being sewn and goes off when sewing is finished.
4 Needle position button
Press the needle position button to raise or lower the needle.
Pressing the button twice sews one stitch.
5 Thread cutter button
Press the thread cutter button after sewing is stopped to cut
both the upper and the bobbin threads.
6 Sewing speed controller
Slide the sewing speed controller to adjust the sewing speed.
The sewing speed cannot be adjusted while sewing decorative
stitches or embroidering.
c
d e
The machine is ready to sew or is sewing.
The machine cannot sew.
The machine is winding the bobbin thread, or
the bobbin winder shaft is moved to the right
side.
f