Attaching The Embroidery Unit - Brother NQ3600D Operation Manual

Attaching the Embroidery Unit

Attaching the Embroidery Unit
CAUTION
• Do not move the machine with the embroidery
unit in place. The embroidery unit may be
dropped and cause injury.
• Keep your hands and other objects away from
the embroidery carriage and frame. Otherwise
injury may result.
Note
• Do not touch the connector in the embroidery
unit connector slot. The connector could be
damaged, and it may cause malfunctions.
• Do not lift up on the embroidery carriage, and do
not forcefully move it. It may cause malfunctions.
a Turn off the machine.
CAUTION
• Before attaching the embroidery unit, be sure
to turn off the machine. Otherwise, injuries
may occur if one of the operation buttons is
accidentally pressed and the machine starts
sewing.
b Pull the flat bed attachment off to the left.
B-54
c Slide the tab on the cover of the connection port in the
direction of the arrow to open the cover.
Note
• Be sure to close the cover of the connection port
when the embroidery unit is not being used.
d Insert the embroidery unit connector into the
connection port, and then lightly push in the
embroidery unit until it snaps into place.
1 Connection port
2 Embroidery unit connector
Note
• Make sure that there is no gap between the
embroidery unit and the machine, otherwise the
embroidery pattern may not be sewn correctly.
Be sure to fully insert the connector into the
connection port.
• Do not push on the carriage when attaching the
embroidery unit to the machine, otherwise
damage to the embroidery unit may result.
e Turn on the machine.
 A message appears in the screen.
f Be sure that no objects or hands are near the
embroidery unit and press
 The carriage moves to its initial position.
1
2
.