Operation - Dometic SMRTSTACRV Installation And Operation Manual

SmartStart RV Soft Start Accessory
4. Place the device on the fan motor, ensuring the hose
clamp remains in the gap between the fan motor and
the mounting flange.
5. Avoiding any wires, route the hose clamp ends
around the fan motor so the ends meet.
6. Use the connected worm screw to hold the hose
clamp ends around the fan motor.
I If the mounting bracket moved during the
previous step, reposition the mounting bracket
in the gap.
7. Using the 1/4-4 in. flathead screwdriver, tighten the
worm screw on the hose clamp until snug and secure
the device to the fan motor.
8. Turn the worm screw an additional one-half turn.
44 Replacing the Foam Shroud
Foam Shroud
q
9. Verify the replaced electrical box foam is in the
proper location.
10. Ensure the electrical box foam fits flush with the front
edge of the foam shroud or adjust into place.
11. Replace the internal foam shroud onto the AC unit.
EN
q q
w w
Electrical Box Foam
w
7 .3 .7 Connecting the Harnesses to the
Device
r r
e e
w w
45 Connecting the Harnesses to the Device
Foam Shroud
q
Supply Wire
w
Harness Path
Capillary Tube Coil
e
1. Route the supply wire harness along the outer edge
of the existing factory supply wire harness.
2. Verify the supply wire harness routes under the
capillary tube coil.
3. Connect the compressor harness connector to the
compressor side of the device.
4. Connect the supply wire harness connector to the
supply side of the device.
7 .3 .8 Replacing the AC Shroud
Using the #2 Phillips screwdriver, replace the nine AC
shroud screws and secure the AC shroud in place.

8 Operation

Once installed, the device operates without need for
user input. See the specific AC unit's Installation and
Operation Manual for AC operating instructions.
Operation
t t
q q
Compressor
r
Harness Connector
Device
t
25