Mitsubishi Electric 800 Series Instruction Manual page 19

2.
Wire the shielded twisted pair cable after stripping its sheath to make its cables loose.
Also, protect the shielded cable of the shielded twisted pair cable to ensure that it will not make contact with the
conductive area.
Strip the signal wires as follows. If too much of the wire is stripped, a short circuit may occur with neighboring wires. If not
enough of the wire is stripped, wires may become loose and fall out.
Twist the stripped end of wires to prevent them from fraying. Do not solder them.
Use a crimp terminal as necessary.
When using the crimp terminal, make sure that the stranded wire do not come out of the terminal.
Shield
(perform protective treatment)
Sheath
Shielded twisted pair cable
Cable stripping length
5 mm
Damaged
Wires are not inserted
Crumpled tip into the sleeve
INSTALLATION AND WIRING
2
Unstranded
wires
19