Mitsubishi Electric 800 Series Instruction Manual page 15

Hide thumbs Also See for 800 Series:

Table of Contents

 Terminating resistor selection switch (SW1)

Select "ON"/"OFF" of the internal terminating resistor.

Set the switch to "ON" (initial status) when an encoder output type is differential line driver and set to "OFF" when

complementary.

ON : with internal terminating resistor (initial setting status)

OFF : without internal terminating resistor

NOTE

• Set all switches to the same setting ("ON"/ "OFF").

• If the encoder output type is differential line driver, set the terminating resistor switch to the "OFF" position when sharing the

same encoder with other unit (CNC (computerized numerical controller), etc) or a terminating resistor is connected to other

unit.

Internal terminating

resistor-ON

(initial status)

Internal terminating

resistor-OFF

SW2

SW3

INSTALLATION AND WIRING

Table of Contents

Fr-a8ap