Sunrise Medical QUICKIE Sedeo Pro Advanced Seating Manual page 33

Recommended process to move the seat from standing
to seated within the emergency mode
i. When in Emergency Seating Mode select the Forward Tilt
function by deflecting the joystick left/right until you see
it described in the display.
ii. Pull the joystick back and bring the seat into a
horizontal position.
iii. Operate the Foot Lift angle down to the 90° position.
Make sure that the bottom rear of the footplates do not
touch the ground. If this is the case move the Foot Length
actuator to a shorter position and then continue to
achieve the 90° legrest position.
iv. Select the Backrest Recline actuator and move it upwards
to a comfortable user position.
v. Now select again the Forward Tilt actuator and move it
further down. Watch the rear of the seat frame and stop
the down movement if there is a clash risk between the
rear seat frame and the motor/brake.
vi. You may solve this situation by selecting the Tilt Back and
move this down. Watch the legrest rear part to prevent
clashes between the legrest and the front chassis.
vii. This procedure will bring the seat into a comfortable user
position to either exit the seat/chair or, after the motor brake
release and switching off the chair, to push it with the user
viii. To exit the Emergency Seat Mode simply power cycle the
wheel chair (switch off and on again).
NOTE!
Circumstances that do not allow the chair to switch to the
Emergency Seating Mode:
1. No Battery Power
2. 1 or more Actuator power cables cut
3. Both Caster Lock Actuators are not detected by the
Seating Module
4. Forward Tilt power supply for the feedback system
not present
5. Malfunction of any module preventing the Joystick to
select seating mode
WARNING!
Whenever you have used the Emergency Seating Mode we
strongly recommend you contact your Service
Provider immediately.
Sedeo Pro Advanced/Advanced UP Rev.A
33