Back Adjustments; Sedeo Pro Adjustable Back; Jay Syncra - Sunrise Medical QUICKIE Sedeo Pro Advanced Seating Manual

4.7 Back Adjustments

4.7.1 Sedeo Pro Adjustable Back

Backrest height (Fig 4.21)
1. Loosen (A) by one turn.
2. Adjust (B) to the desired position.
3. Tighten (A).
Backrest Flexible curvature (Fig. 4.22)
The wheelchair has a padded backrest that can be adjusted
to the curvature of the back in order to achieve a comfortable
sitting position and good stability. The user can sit in the
wheelchair when adjustments are being made to the curvature
of the backrest.
1. Open zipper
2. Press A to release strap
3. Release or tighten each strap individually
4. Release A to keep the setting of the strap

4.7.2 JAY Syncra

Mounting and adjusting the Syncra Back should be done
without the user in the power chair.
Remove the foam and cover from the back shell until the
mounting and adjustments are complete. Once complete,
replace foam and cover to the shell assembly.
After finishing the Syncra Back installation, the user can be
seated back in the wheelchair.
Height Adjustment (Fig. 4.23)
1. Using 5mm hex key, loosen four M8 flanged button head
cap screws (D).
2. Slide shell assembly up or down to desired height.
3. Re-tighten the screws.
2" of height adjustment is available in the shell assembly.
If a lower back height is desired, shell assembly (E) can be
placed in bottom holes of the bracket.
D. Width Adjustment (Fig. 4.24)
Shell assembly can grow a total of 2" (1" per each shell side).
Foam and cover can accommodate a total of 1" width growth.
If more than 1" of width growth is needed, new foam and
cover must be ordered in the next size.
Please contact your dealer or Sunrise Medical.
16
A
2
1
E
D
F
Sedeo Pro Advanced/Advanced UP Rev.A
Fig. 4.21
B
Fig. 4.22
A
3
Fig. 4.23
Fig. 4.24
D