VTech Analog Next Gen Series User Manual page 25

Question
2. There is no dial tone.
3. I cannot dial out.
4. The LOW BATTERY LED illuminates on the
cordless handset.
Suggestions
• Try all the above suggestions.
• Make sure there is a dial tone before
dialing. It is normal if the cordless handset
takes a second or two to synchronize with
the telephone base before producing a dial
tone. Wait an extra second before dialing.
• Eliminate any background noise. Mute the
telephone before dialing, if applicable, or
dial from another room in your unit with less
background noise.
• If other telephones in your hotel are having
the same problem, the problem is in the
wiring or telephone service. Contact your
telephone service provider (charges may
apply).
• Try all the above suggestions.
• Make sure there is a dial tone before dialing.
• Eliminate any background noise. Mute the
telephone before dialing, if applicable, or
dial from another room in your unit with less
background noise.
• If other telephones in your hotel are having
the same problem, the problem is in the
wiring or telephone service. Contact your
telephone service provider (charges may
apply).
• Place the cordless handset in the telephone
base or charging base for recharging.
• Remove the battery and then install it again,
and use it until fully depleted. Then charge
the cordless handset in the telephone base
or charging base for up to 11 hours.
• If the above measures do not correct the
problem, replace the battery.
EN - 25