Advertisement
CLX3300 Series with BHSS Trim
Installation Instructions
4
Latch Installation
Insert latch in door. (Be sure bevel edge of bolt faces strike plate.)
Attach with (2) #8-32 x 3/4" screws supplied.
Important: Deadlocking latch must stop on strike when door is closed.
5
Door Thickness Adjustment (if necessary)
Lock is factory preset for 1-3/4" (44mm) doors unless specified. To adjust lock to door thickness if other than 1-3/4" (44mm):
1. Remove outside spring housing from lockbody assembly. (Figure 5)
2. Rotate outside rose liner to adjust lock to fit door thickness, so distance (Dimension A) from inside surface of liner to
centerline of retractor is half the thickness of the door. (See chart and Figure 6)
3. Reassemble outside spring housing onto lockbody assembly.
Outside Rose
Lockbody
Liner
Assembly
Figure 5
6
Install Outside Lockbody Assembly
To adjust lock to door thickness if other than 1-3/4"
(44mm) refer to Section 5.
Insert lockbody assembly into door from outside
making sure that lockbody hooks latch case and
retractor engages bolt tail(s). (Figure 7)
DO NOT FORCE. (If lockbody does not engage latch
easily, check door preparation for errors.)
Latch bolt tail should be centered in depth of
retractor. If it is not, refer to Section 5 to properly
adjust the lock for door thickness.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com •www.corbinrusswin.com
Copyright © 2022, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Strike
Retractor
Door Thickness
1-3/4" (44 mm)
2" (50 mm)
Centerline of Retractor
Dimension A
2
Dimension A
7/8" (22 mm)
1" (25 mm)
FM589 07/22
Advertisement
