Specifications - Makita DCC500 Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Model:
Wheel diameter
Max. wheel thickness
Max. cutting capacities
Rated speed (n)
Overall length
Rated voltage
Net weight
*1. With battery cartridge (BL1860B).
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combinations, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for cutting in brick and concrete
without the use of water. With appropriate Makita genu-
ine water supply cover, wet cutting can be performed.
Noise
The typical A-weighted noise level determined accord-
ing to EN60745-2-22:
Sound pressure level (L
Sound power level (L ) : 107 dB (A)
WA
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
0° bevel angle
45° bevel angle
) : 96 dB(A)
pA
BL1815N / BL1820B / BL1830B / BL1840B / BL1850B / BL1860B
DC18RC / DC18RD / DC18RE / DC18SD / DC18SE / DC18SF /
WARNING:
WARNING:
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN60745-2-22:
Work mode: concrete cutting
Vibration emission (a
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration total value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared vibration total value(s) may also
be used in a preliminary assessment of exposure.
10 ENGLISH
DCC500
125 mm
2.2 mm
40 mm
27 mm
-1
8,800 min
283 mm *1
D.C. 18 V
2.5 - 3.0 kg
DC18SH
Wear ear protection.
The noise emission during actual
Be sure to identify safety mea-
2
) : 4.0 m/s
h
2