Specifications - Makita 4101RH Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Wheel diameter
Max. wheel thickness
Max. cutting capacities
Max. permitted pressure of water supply
Rated speed (n) / No load speed (n
Overall length
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
Read instruction manual.
Wear safety glasses.
The tool should be used on horizontal
surfaces.
Do not use the tool upside down.
The tool should be used with the PRCD
(Portable Residual Current Device).
Do not use the abrasive cut-off wheel.
After use, brush off accumulation of dust
on the base.
Do not use the saw blade.
Only for EU countries
Due to the presence of hazardous compo-
nents in the equipment, used electrical and
electronic equipment may have a negative
impact on the environment and human health.
Do not dispose of electrical and electronic
appliances with household waste!
In accordance with the European Directive
on waste electrical and electronic equipment
and its adaptation to national law, used
electrical and electronic equipment should
be collected separately and delivered to
a separate collection point for municipal
waste, operating in accordance with the
environmental protection regulations.
This is indicated by the symbol of the
crossed-out wheeled bin placed on the
equipment.
Model
90°
45°
)
0
Net weight
Safety class
Intended use
The tool is intended for cutting in brick, concrete and stone.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. This
tool should be grounded while in use to protect the oper-
ator from electric shock. Use only three-wire extension
cords which have three-prong grounding-type plugs and
three-pole receptacles which accept the tool's plug.
Noise
The typical A-weighted noise level determined accord-
ing to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN60745:
Work mode : concrete cutting
Vibration emission (a
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration emission value has been
measured in accordance with the standard test method
and may be used for comparing one tool with another.
NOTE: The declared vibration emission value may
also be used in a preliminary assessment of exposure.
The vibration emission during actual
WARNING:
use of the power tool can differ from the declared emission
value depending on the ways in which the tool is used.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).
4 ENGLISH
4101RH
125 mm
2.1 mm
41.5 mm
26 mm
0.14 MPa
-1
13,800 (min )
236 mm
3.0 kg
Class I
) : 98 dB (A)
pA
) : 109 dB (A)
WA
2
) : 5.5 m/s
h
2