Lorex LH314 Instruction Manual page 71

Networking Checklist
Use this checklist to confirm you have completed all the steps of the Network Setup.
I have the following:
• High-Speed Internet
• Router
• Ethernet cable (included with the system)
• Computer with Internet Explorer 6 or later
I have turned off the system and performed the following:
• Connected the Ethernet cable to the back of the system
• Connected the other end of the Ethernet cable to my router
• Entered the IP address and Default Gateway from ipconfig in my system's LAN settings (
model only )
NOTE:
Network Setup will not work if you do not have a router.
I have found my System Information:
• Press the
OR
• From the Main Menu, click
under LAN.
My IP Address is: ________________________________________________
My MAC Address is: ______________________________________________
I have configured QuickTime
You must enable HTTP as the transfer protocol and select port 80.
NOTE:
You must configure QuickTime in this manner for
I have enabled Port Forwarding on my router:
• Port 80
• Port 8090 (4-channel
NOTE:
For added security, we strongly recommend changing HTTP port 80 on the system to
port —the port must not blocked by your Internet service provider (ISP). For details on changing your
ports, see "Appendix C: Changing Ports On Your System" on page 61.
NOTE:
Each router is different, so port forwarding settings vary by model. Please visit us on the web at
www.lorexcctv.com for assistance with the latest types of routers. If your router is not listed, please refer
to your router's manual or contact your router's manufacturer for assistance.
twice
button on the remote control.
, and then click
(4-channel only)
only )
Appendix B: Setting up Local and Remote Viewing
Information
. Your IP address and MAC address are
:
EVERY PC
that will have access to your system.
4-channel
any desired
59