Lorex LH314 Instruction Manual page 65

5. Type ipconfig and press Enter. Your network information appears (see figure 24.1). You may
need to enter some of this information in your system's LAN settings.
Figure 24.1 IP configuration information
6. On the system, click
• If the IP address and Gateway are the SAME as those in ipconfig on your PC, your system
is connected to your local network.
• If the IP address and Gateway are DIFFERENT than those in ipconfig on your PC, go to
step 5.
7. Under IP, select the third field (001) and enter the third set of numbers from the IP address
in the Command Prompt window. Under Gateway, select the third field (001) and enter the
third set of numbers from the Default Gateway in the Command Prompt window Right-click
to exit all menus to save your settings (or press the ESC button on the remote control).
Figure 24.2 Default IP address and Gateway
Figure 24.3 New IP address and Gateway
to open the Main Menu. Click
Appendix B: Setting up Local and Remote Viewing
Enter the third set of numbers from
the IP address and Gateway in the LAN
settings of your system.
In this example, the number is
LAN
.
NOTE: third set of numbers
The
IP and Gateway in your LAN settings
MUST MATCH
numbers in IP address and Default
Gateway from the IP Config results in
the Command Prompt window. You do
not need to change any of the other
sets of numbers.
NOTE:
In this example, we changed
the default digit from
order to match the IP address and
Default Gateway in ipconfig.
11
.
in
the third set of
001 to 011
in
53