Lorex LH314 Instruction Manual page 64

Appendix B: Setting up Local and Remote Viewing
Connecting to a Network
To connect to a network:
1. Power off your system by disconnecting the power cable from the rear panel.
2. Connect an Ethernet cable (included) to the LAN port on the rear panel of the system.
Connect the other end of the Ethernet cable to an empty LAN port (usually numbered 1~4) on
your router.
INTERNET
(not required for
local viewing)
3. Reconnect the power cable to power the system back on.
NOTE:
If your system has
page 54
to find your IP address for DDNS setup.
4. On your PC, click Start and select Run. In the Run window, enter cmd and click OK. The
Command Prompt window opens.
Figure 24.0 Run window
52
ROUTER
(Not Included)
4 channels step 4
, go to
8 or 16 channels
; If your system has
PC
(Not Included)
, continue to