Advertisement
Step 6: Flushing and checking for leaks
A
Keep inward
Fig 1
Unfiltered Water Function
Pull the hose assembly out of the spout and
remove the spray head (A) by unscrewing it from
the hose in a counterclockwise direction. Be
sure to hold the end of the hose down into the
sink and turn the faucet to the warm position
Cold
Hot
where it mixes hot and cold water.
Pulling the handle towards yourself will turn
the water to hot. Pushing the handle away
from yourself will turn the water to cold.
Flush the water lines for one minute. This
flushes away any debris that could cause
damage to internal parts. Check for leaks.
Re-tighten any connections if necessary, but
Opnn
e
do not overtighten. Reinstall the spray head (A)
by hand tightening it back onto the spray
hose in a clockwise direction.
NOTE: Please make sure washer is installed
attaching spray head to hose.
Filtered Cold Water Function
Make sure the the faucet is closed and do not
open the handle outward, as shown in the Fig 1.
Maintain the state of the Fig 1, pulling the
handle towards yourself will activate the filtered
water, as shown in the Fig 2.
Flush the water lines for one minute. This flushes
away any debris that could cause damage to
internal parts. Check for leaks.
OFF
Maintain the state of the Fig 1, pushing the
handle away from yourself will tur
ON
filtered water, as shown in the Fig 2.
Fig 2
e
8
Advertisement
