Installation; Electrical Connection; General Information; Fixed Connection - Barazza 1FICN9E Instruction Manual

2.1 Electrical connection

Danger of electrocution
Electrical voltage
Have the electrical connection carried
out by qualified technical personnel.
The earth connection is obligatory
according to the methods foreseen by
the safety regulations of the electrical
system.
Turn off the general power supply.

2.2 General information

Check that the characteristics of the
electrical network are suitable for the
data shown on the plate.
The identification plate, with technical
data, serial number and marking is visibly
positioned on the appliance.
The plate must never be removed.
The appliance works with
Use a three-pole cable (3x1.5mm
referring to the internal conductor
section).
Provide for the earth connection with a
cable longer than the others by at least
20mm.

2.3 Fixed connection

If a stationary appliance is not fitted
with a supply cord and a plug, a mean

INSTALLATION

for disconnection from the supply mains
having a contact separation in all poles
that provide full disconnection under
overvoltage category III conditions must
be incorporate in the fixed wiring in
accordance with the wiring rules of the
country where the appliance is installed.
For Australia and New Zealand this
mean of disconnection shall be in
accordance with AS/NZS 3000.
The interruption device must be located
in an easily accessible position and near
the appliance.
2.4 Connection with plug
and socket
Check that the plug and socket are of
the same type.
Avoid using reductions, adapters or
shunts as they could cause heating or
burning.

2.5 For the installer

cable,
2
The plug must remain accessible after
installation. Do not bend or trap the
connection cable to the mains.
The appliance must be installed
according to the installation diagrams.
If the appliance does not function
properly after having carried out all the
checks, refer to the Authorised
Assistance Centre in your area.
When the appliance is correctly
installed, please instruct the user on the
correct method of operation.
10