Selecting An Input Signal; Automatically Adjusting The Picture - Hitachi PJTX200J User's Manual And Operating Manual

Selecting an input signal

1.
To switch between input ports, press the
INPUT button on the projector. Each time
the button is pressed, the projector will
switch between input ports as follows.
COMPONENT VIDEO  S-VIDEO

HDMI  COMPUTER  VIDEO
1.
To select a specific input port directly, press the
PC, HDMI, COMPO, S-VIDEO or VIDEO button
on the remote control according to which port you
want to select.
 PC button  COMPUTER port
 HDMI button  HDMI port
 COMPO button  COMPONENT VIDEO ports
 S-VIDEO button  S-VIDEO port
 VIDEO button  VIDEO port

Automatically adjusting the picture

1.
Press the AUTO button on the remote control to
automatically set or select the following contents.
 For a signal from the COMPUTER port
The vertical position, horizontal position, horizontal
phase, horizontal size and aspect ratio are
automatically set. Make sure that the application
window is set to its maximum size before attempting to use this feature. A dark
picture may be incorrectly adjusted. Use a bright picture when adjusting.
 For a signal from the HDMI port
The aspect ratio is automatically set.
 For a signal from the COMPONENT VIDEO ports
The vertical position, horizontal position and aspect ratio are automatically set.
The horizontal phase is also automatically set except for 525i (480i), 625i (576i)
and SCART RGB signals.
 For a signal from the S-VIDEO or VIDEO port
The video format best suited for the respective input signal will be automatically
selected. This function is available only when the VIDEO FORMAT item in the
INPUT menu (46) is set to AUTO.
The vertical position, horizontal position and aspect ratio are also automatically
set.
NOTE
• The automatic adjustment operation takes approximately 10 seconds.
Automatic adjustment may not function correctly with some input signals.

Projection
21