Panasonic F-VXR50A Operating Instructions Manual page 12

OPERATION
使用方法
Start the product.
开始运转
选择运转模式
全自动
空气净化
加湿空气净化
停止运转
(long press 3 sec)
(The indicator is on)
（长按3秒钟）
（指示灯亮起）
Long press it for 3 seconds again (the indicator is Off).
想取消设置时
再次长按3秒钟(指示灯熄灭）
12
可从「Clean•Humid」的三个模式中选择。
The product will purify the air and adjust
the best humidity automatically according
to the degrees of the dirt and humidity.
The air flow and air volume are controlled
automatically. (They cannot be switched
manually.)
If there is no water, the product will
switch to the Clean Air mode.
When generating
To save the electricity fees
No water is required.
When generating
To specify the air flow and air volume
To save the electricity fees
When water remains in the tank, it will
humidify slightly.(Water in the tank will
decrease slightly.)If you worry about the
humidifying effect, please empty the
water tank and water tray.
The product cannot operate without water.
When generating
To specify the air flow and air volume
To save the electricity fees
For the details on the air flow and air volume,Econavi made, please refer to the next
page.
关于气流、风量及Econavi的详细内容请浏览下一页。
儿童安全锁
It can prevent the children from
playing it.
With this setting, if you press a
button other than the
the product will beep twice, and
cannot be operated.
可以防止儿童的玩耍操作。
设置后，若按 以外的
则会发出Bi～Bi～提示音，
无法操作。
想自动运转时
®
nanoe .
想净化空气时
nanoe ® .
想一边加湿一边净化空气时
nanoe ® .
Press this button to enable the Timer mode:2
hours Timer, 4 hours Timer or Sleep(8 h). In
the Sleep (8 h) mode, the front indicators and
the air volume indicator are off. The operation
, indicators at the top dims, and the product
starts operation at a low speed.
按下此按钮启动定时模式，定时时间为2
小时、4小时或睡眠模式（8小时）。睡眠
模式（8小时）运转时，前方指示灯和风
（指示灯亮起）
量指示灯熄灭，顶部操作指示灯变暗，
开始低速运转。
Press this button repeatedly until the 2 hour timer,4
hour timer and Sleep indicators are all off.
想取消设置时
连续按下按钮至2、4睡眠模式指示灯全部熄灭
根据污染和湿度的程度，自行运转
净化空气、调节最佳湿度。
空气流动和风量为自动控制。(无法
手动切换)
若无水，则变「Clean Air」为运转
模式。
®
正在产生「nanoe 」
想节约电费时
不需要水。
®
正在产生「nanoe 」
想指定气流·风量时
想节约电费时
水箱里有水时，会在此水作用下进行
少量加湿。（水箱里的水稍微减少）
如果不想要加湿效果，请倒掉水箱和
水盘内的水。
若无水，则无法运转。
nanoe
正在产生「 ® 」
想指定气流·风量时
想节约电费时
定时