Requirement after parts replacement
Following adjustments are required when print circuit board or part is replaced.
Replaced print circuit board or par t
MAIN Control Board
Flash ROM ( It isnt Service parts. )
Front CIS
Back CIS
Front & Back CIS
Starting Position Sensor Board
Starting Position LED Board
Waiting Sensor Board
Waiting LED Board
Initialize EEPROM (It isnt Service Parts.)
Adjust Shading
Adjust All Position & Length Automatically
Adjust Double Feed Detector Gain
Adjust Shading
Adjust Shading
Adjust All Position & Length Automatically or the following two Adjustments should be
done.
(1) Adjust Front H. Position Automatically
(2) Adjust Front V. PositionAutomatically
*When Adjust All Position & Length Automatically is done, Length, Back H. Position, and
Back V. Position are adjusted again.
Adjust Shading
Adjust All Position & Length Automatically or 2 Adjustments should be done.
(1) Adjust Back H. Position Automatically
(2) Adjust Back V. Position Automatically
*When AdjustAll Position & Length Automatically is done, Length, Front H. Position, and
Front V. Position are adjusted again.
Adjust Shading
Adjust All Position & Length Automatically or 4 Adjustments should be done.
(1) Adjust Front H. Position Automatically
(2) Adjust Front V. Position Automatically
(3)Adjust Back H. Position Automatically
(4) Adjust Back V. Position Automatically
*When Adjust All Position & Length Automatically is done, Length is adjusted again.
Adjust All Position & Length Automatically or 2 Adjustments should be done.
(1) Adjust Front H. Position Automatically
(2) Adjust Back V. Position Automatically
Adjust Double Feed Detector Gain
• Adjust All Position & Length Automatically
• Adjust Double Feed sensitivity
EEPROM
check Error
MAIN Board
Error
(Another
model MAIN
Board is
supplied.)
No Error
Required adjustment
Replace MAIN Control
Board
Replace MAIN Control
Board